首页 > 产品中心 > 发电机产品 > 60V FOC矢量控制器
60V FOC矢量控制器
安托山自主研发的矢量正弦驱动器主要功能:
1. 针对无铁芯电机做了深度开发,系统的效能进一步提升。
   For coreless motor to do the depth of development,further enhancing the effectiveness of the system.
2. 采用先进的DSP控制技术,用FOC的控制算法,FOC-180°正弦波矢量控制,输出力矩脉动小,效率高,起步及加速舒适平顺,体验好
   Using advanced DSP control algorithm,FOC-180°degree sine wave vector control,output torque ripple small,high efficiency,starting and accelerating comfortable ride comfort,good experience.
3. 匹配永磁同步无铁心电机系统效率高达90%,30%以上负载区间的效率均在80%以上;
   Matching system of permanent magnet synchronous coreless motor efficiency as high as 90%,more than 30% efficiency of load intervals are more than 80%.
4. 电机初始位置偏移角自学习功能,提供精准的力矩控制;
   Offset angle from the initial position of motor learning function,providing accurate torque control.
5. 温控自动调节功能,根据电机及控制器温度实时调节,过热情况下,线性削弱电流输出,保护系统安全运行;
   Automatic temperature regulation function,according to the motor and controller used to adjust temperature,overheating cases,linear current output weakened to protect the safe operation of the system.
6. 提供各种保护:堵转,过载,过温,过压,过流,欠压,飞车,断线,短路保护等故障保护,系统安全可靠.
   Provide a variety of protection:stall overload,over-temperature,over-voltage,over current,under voltage,speed,break,short circuit protection,fault protection,system security and reliability.
7. 支持串口485,CAN2.0通信协议,蓝牙等功能;
  Support the serial port 485,communication protocol,Bluetooth and other functions.

产品型号 功率等级(kw) 直流侧额定
工作电压(Vdc)
直流侧最大
工作电流(Idc)
最大相电流
(Arms)
YCWK060060H 2 60 60 110
YCWK060080H 3 60 80 141